"The proposal tackles the CfP JTI-CS-2012-1-GRA-02-019. Within the project a Wind-Tunnel-Model is designed, built and tested that is capable of being tested with two main purposes:- access the extend of laminarity on the wing- evaluate the performance of LC&A system in the trailing edge of the wingIn order to do this the project tackles different points:- a model design is performed that creates a wind-tunnel model with an elastic behaviour comparable to the full-scale wing. This model is as big as possible, although fulfilling all specifications in terms of wind-tunnel restrictions (size, maximum force) in order to allow a hig Reynolds-Number and therefore allow to assess the laminar extend on the wing during the tests in a way that the results are comparable to the full-scale tests.- a first possible LC&A solution which is input to the project is evaluated and optimized and compared with a solution, that was newly designed and optimized LC&A within the project. The best solution is scaled down to model scale and implemented into the model.Within the tests step/ gaps and contaminats are introduced to the model in order to evaluate the stability of the laminar behaviour of the wing with respect to this parameters. In the second test-phase the LC&A devices are used in order to modify the load-distribution on the wing. Before testing the model-wing a ground-vibration test is performed in order to show that the model can be operated safely in the wind-tunnel."